Nascomatic Driver Units

standard options | drivers | configurations| jaw units

Tool Support Systems

 

Nasco Industries • 3541 N.W. 53rd Street • Ft. Lauderdale FL 33309
Phone
: 1-954-733-8665 • Toll Free: 1-800-9-NASCO-9
Fax: 1-954-733-8669 • Email: nasco@bellsouth.net

 

Screwfeeders and Presenters
Overhead Runway Tool Supports
Tool Balancers and Load Positioning Systems
Torque Wrenches and Drivers
IN-LINE DRIVER
  • The most popular configuration for hand held applications.
  • Available in a wide selection of speeds, max. torque and type of clutch.
  • Supplied as a push-to-start or lever start driver with or without a reverse capability.
DELTA DRIVER
  • Allows access into recesses.
  • Driver jaw never touches work surface thereby preventing damage to finish.
  • Linear Lock provided as a standard feature.
PISTOL GRIP DRIVER
  • Available in a wide selection of speeds, max. torque and type of clutch.
  • Supplied as a push-to-start or trigger start driver with or without a reverse capability.
ELECTRIC DRIVER
  • Supplied as a push-to-start or lever start driver with a reverse capability.
  • Automatic shut-off clutch.
  • Pistol grip adapter available.
  • Available in a wide selection of speeds and maximum torque.
  • Driver powered by either AC or low voltage DC via controller.
PISTOL GRIP ADAPTER
  • Mounts to in-line driver yet is readily removable.
  • Creates a pistol grip drive configuration with ideal tool balance.
  • Brings operator's hand closer to assembly components for easier targeting.
  • Accommodates push-to-start and trigger start drivers.

 

 

 

view demo

  • For secure screwdriving at any angle.
  • Screws are seated against drive tip and held tightly until completely driven.
  • Allows driving in any orientation, even vertically upward.
  • Available on all Nascomatic drivers.
   
   
AUTO-EXTEND DRIVER (AED)
  • For fixture mounted and robotic applications.
  • As small as 16" long and under 2.5 lbs.
  • Can be equipped with automatic shutoff, ratcheting or stall type clutch.
  • Available with a wide variety of sensors such as depth, torque, screw presence, part in place and driver clear of part.
The AED system can be assembled into multi-driver configurations with screw centerline separations of less than 1-1/2"

AED shown mounted to a linear thruster on a custom stand.